Highline Tungsten Carbide Table Saw Dado Blade Set w/Z4 Chippers Size:CIR 8 x 1/8-13/16 x 5/8 Z24x24 -5 and Lmin on drawing =

and Lmin on drawing = minimum shaft length

The shorter center point allows for drilling deep holes close to the bottom of the panel and these ‘light’ drills bring lower cutting pressure

In this case the Leuco Q-Cut G6 is ready for the challenge on your horizontal beam saw machine

NL**- Combi3 = 2/7/42 + 2/9/46 + 2/9

Highline Tungsten Carbide Table Saw Dado Blade Set w/Z4 Chippers Size:CIR 8 x 1/8-13/16 x 5/8 Z24x24 -5 and Lmin on drawing =Dado sets are used in table saws for dado cuts in solid wood & wood based panels. The HL board 10 carbide brings optimum cutting quality & extended edge life. (Alteration of bore possible if needed.)