Automatic electrical controls - Particular requirements for humidity sensing controls Ingestion-build-86103 The sorbent tube approach is

The sorbent tube approach is intended for use under relatively low particulate conditions (typically less than 100 mg/m3) when monitoring downstream of all pollution control devices

Normative references and bibliography updated

BS EN 16357 assesses the speed and effectiveness of their neutralising potential by automatic titration with citric acid

provides recommendations for the selection and installation of new passenger and passenger/goods lifts

Automatic electrical controls - Particular requirements for humidity sensing controls Ingestion-build-86103 The sorbent tube approach is1 Scope and normative references This clause of Part 1 is applicable except as follows: 1. 1 Scope Replacement: This part of IEC 60730 applies to automatic electrical humidity sensing controls for use in, on or in association with equipment, including controls for heating, air conditioning and similar applications. The equipment may use electricity, gas, oil, solid fuel, solar thermal energy, etc. or a combination thereof. NOTE Throughout this