RMRRF Top Duel Dragster Axel Shafts Shaft Type:Geared Shaft - No Offset Cut Make sure the Printed Wheel

Make sure the Printed Wheel Hubs you choose will work with the Shaft or has a 8mm hole for the rod to center the wheel hub

A part of every sale will go to help fund future work by the Creator

This board comes fully soldered with a Seeeduino Xiao

These should not need a new flash

RMRRF Top Duel Dragster Axel Shafts Shaft Type:Geared Shaft - No Offset Cut Make sure the Printed WheelCNC Cut Combo Axel Shafts for RMRRF Top Fuel Dragster Designed by Scott Edge of 3D Shafts are cut from ~200mm length 8mm Linear Rod, they are Based on the Geared Shaft option with the Belted Pulley cut out added, each cut has been enlarged by ~1mm in width and cut 2mm into the rod for a strong flat surface for gub screws to attach. Spacing: Centering Shaft ~165mm from outer Frame to Axel end on each side Flange for Wheels ~15mm Make sure the Printed