Micro Swiss Brass Plated Wear Resistant Nozzle for Creality Ender 7 / Ender 5 S1 / Ender 3 V3 SE Size:0.4mm 8x M3 square nuts for

8x M3 square nuts for reinforcing mounting holes

Standard DREMC Colours in ABS/ABS+: (ASA is available if we are low on ABS+ we will switch at no additional cost)

PLA prints with small contact area may require brim on textured PEI

TMC2209 Silent Step Sticks have output drivers with a lower power dissipation and a higher current is possible

Micro Swiss Brass Plated Wear Resistant Nozzle for Creality Ender 7 / Ender 5 S1 / Ender 3 V3 SE Size:0.4mm 8x M3 square nuts forNozzle is made from a 360 brass base material and plated with TwinClad XT coating. TwinClad XT is a nickel composite coating designed for very low friction. It offers one of the lowest coefficient of friction, better than nickel with PTFE co deposit. The TwinClad XT coating is also very hard and abrasion resistant. If you are working with abrasive Carbon Fiber, Stainless Steel, wood filled or any other metal filled filaments, this will greatly improve